Free MCQs & Online Quiz Practice for Exams

Q: Which apparatus is commonly used to determine the standard consistency of cement?

A) Slump cone

B) Proctor apparatus

C) Le Chatelier apparatus

D) Vicat apparatus

Q: Which soil classification is generally associated with the smallest particle size among the following?

A) Sand

B) Clay

C) Silt

D) Gravel

Q: Which aggregate shape is generally preferred for producing good concrete workability?

A) Highly elongated

B) Rounded or cubical

C) Highly flaky

D) Extremely angular only

Q: Which material is commonly used as prestressing reinforcement?

A) High-strength steel

B) Cast iron only

C) Timber

D) Brick

Q: What is a one-way slab generally characterized by?

A) Absence of reinforcement

B) Load being transferred only vertically to soil

C) Equal support on all four sides only

D) Load being mainly transferred in one direction

Q: What is the main purpose of a column tie?

A) To replace the footing

B) To measure column height

C) To restrain longitudinal reinforcement and help resist lateral effects

D) To increase concrete water content

Q: Which pavement generally uses bituminous materials as a major surface or structural component?

A) Rigid pavement

B) Timber pavement

C) Flexible pavement

D) Glass pavement

Q: Which type of cement is suitable where high early strength is required?

A) Rapid hardening cement

B) Low heat cement

C) Air-entraining cement

D) Sulphate resisting cement

Q: During concrete placement, what should a site engineer monitor most closely?

A) Mix quality, placement, compaction, levels and curing requirements

B) Only paint selection

C) Only vehicle movement

D) Only worker attendance

Q: In a normally reinforced concrete beam under positive bending, concrete mainly resists?

A) Compression

B) Torsion only

C) No stress

D) Tension

Q: What is GPS commonly used for in modern surveying?

A) Determining positions and coordinates using satellite signals

B) Determining cement setting time

C) Testing aggregate strength

D) Measuring concrete slump

Q: What is plastic limit represent?

A) The groundwater table depth

B) The soil's specific gravity

C) The water content at the boundary between plastic and semi-solid states

D) The maximum water pressure

Q: What is the arithmetic check in levelling used for?

A) To calculate concrete mix design

B) To measure road width

C) To verify the consistency of calculated reduced levels and observations

D) To determine soil classification

Q: What is setting out in construction?

A) Transferring the dimensions and positions shown on drawings onto the ground

B) Testing concrete cubes

C) Removing soil from a foundation

D) Applying waterproofing

Q: What is a total station?

A) To compact soil

B) To test concrete strength

C) To measure cement fineness

D) To electronically measure angles and distances and assist in coordinate determination

Q: What is the main function of an accelerating admixture?

A) To reduce cement hydration

B) To increase setting time

C) To speed up setting or early strength development

D) To increase soil permeability

Q: What is the main purpose of a site survey before setting out a building?

A) To determine worker salaries

B) To establish accurate positions, dimensions and levels from design information

C) To test concrete strength

D) To select wall paint

Q: What is a traverse in surveying?

A) A single contour line

B) A soil classification method

C) A concrete foundation

D) A series of connected survey lines whose lengths and directions are measured

Q: Which soil is most likely to experience significant consolidation settlement?

A) Soft saturated clay

B) Dense gravel

C) Hard rock

D) Coarse sand

Q: What is the main responsibility of a civil engineer during construction?

A) To perform only administrative tasks

B) To purchase all materials personally

C) To ensure work is executed according to approved designs, specifications, quality requirements and applicable procedures

D) To operate every construction machine